7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Revision 1.1.3 Page - 53
7.6.1.2. Inverse Telecine
The 7814 series modules have the ability to automatically detect embedded 3:2 and 2:2 sequences.
When such sequences are present inverse 3:2 and 2:2 is performed so that mathematically lossless
conversion back to progressive may be achieved. For optimal performance, the Auto mode of operation is
highly recommended. The Inverse Telecine drop down menu enables the user to set the operating mode
as shown below:
Enable All
The card will automatically detect video sequences including embedded 3:2
and embedded 2:2 sequences and more as listed in the Cadence List.
Processing will be automatically adapted to match the detect content. If no film
mode sequence is detected, the de-interlacer will automatically revert to video
mode processing. This is the recommended setting for this control.
Enable Selected
The module will only initialize the de-interlacer when the selected Cadence(s)
are detected. For a full list of available cadences, see section 7.6.1.3.
Disable
The video de-interlacer will operate in video only
mode and will utilize its
internal motion adaptive and edge interpolation process for de-
input signal.
To Next Page
Loading...
