7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Revision 1.1.3 Page - 43
7.1.2. Video Monitor
The Video Monitor section enables the user to view the status of video related parameters. The following
sections describe the monitoring in detail.
7.1.2.1. PGM IN A Video Standard
The PGM IN A DIN Video Std reports if a valid video signal is presented to PGM IN A and what standard
has been detected when it is present.
7.1.2.2. PGM IN B Video Standard
PGM IN B DIN Video Std reports if a valid video signal is presented to PGM IN B and what standard has
been detected when it is present.
7.1.2.3. Input Video BNC
Input Video DIN reports what input DIN has been selected to pass through the main up/down/cross
conversion path.
7.1.2.4. Video Delay
Video Delay reports video delay through the card in ms.
7.1.2.5. Video Payload ID
Video Payload ID reports if a valid Video Payload ID ANC packet has been detected and will display the
decoded video format information.
7.1.3. Video Traps
To enable a specific Fault trap, click the small box beside the relevant fault and ensure that a check mark
appears in the box. To disable a specific Fault trap, click the small box beside the relevant fault and
ensure that a check mark does not appear in the box.
To Next Page
Loading...
