7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Revision 1.1.3 Page - 147
Output Loudness
Reports a real time value of the calculated output loudness
value. This control is used for monitoring purposes only.
124
Output SMPTE2016-1 Code
Status
Presents the AFD code being stamped on the output of the
card (if applicable).
58
PGM IN A Video Standard
Reports if a valid video signal is presented to the SDI input
and what standard has been detected when it is present.
43
PGM IN B Video Standard
Reports if a valid video signal is presented to Fiber input
and what standard has been detected when it is present.
43
Reference Status
Reports what the current valid reference standard is being
applied to the module
129
Reference Type
Reports whether the incoming genlock signal is of bi-level
129
Serial Number
Reports the serial number that is loaded by the
manufacturer.
33
SRC Status
Displays the status of the Sample Rate Converters. 80
Stereo or 5.1
Displays the audio detected on the input of the up-mix block 103
UpMix Status
Displays the up-mix status (UpMix or Bypass) 103
Video Delay
Reports video delay through the card in ms. 43
Video Delay
Displays the delay of the associated video in ms. 80
Video Payload ID
Reports if a valid Video Payload ID ANC packet has been
detected and indicates the format that the video is being
sent to the card.
43
Table 9-1: VistaLINK
®
Monitored Parameters
To Next Page
Loading...
