evertz MultiFrame 7814 Series - Vistalink Controlled Parameters

7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Page - 148 Revision 1.1.3
9.3. VISTALINK
®
CONTROLLED PARAMETERS
Parameter
Description
Pg.
5.1 Detection Threshold
Sets the audio level below which the 5.1 source is considered
absent.
103
AES AIC Gain
Used to correct audio levels of the AES audio input. 82
AES AIC Inversion
Used to correct the inversion of the AES audio input 82
AES Gain Adjust X
Sets the value of the gain from the selected source. 90
AES Gain Adjust Y
Sets the value of the gain from the selected source. 92
AES Invert Enable X
Inverts the phase or passes the selected audio channels. 90
AES Invert Enable Y
Inverts the phase or passes the selected audio channels. 92
AES Source X
Routes one of the 16 input audio channels to the X input of the
Channel 1 mixer.
89
AES Source Y
Routes one of the 16 input audio channels to the Y input of the
Channel 1 mixer.
91
AFD Input Processing
Enable Control
Enables the input side AFD processing. 55
AFD Output SD Aspect
Ratio
Defines whether SD outputs should be stamped with an AFD value
that indicates a 16:9 or 4:3 output image raster.
56
AFD Select
Selects the incoming AFD code. 66
AFD Stamp
Selects the AFD signal that will be stamped on the output signal. 73
AFD Stamp Settings
Specifies the outgoing AFD code. 67
AFD Stamp Source
Sets the source for output AFD stamping. 56
ANC-LTC Source
This control selects the source of Timecode for the ANC-LTC
timecode to be embedded on the output
131
ANC-VITC Source
This control selects the source of Timecode for the ANC-VITC
timecode to be embedded on the output.
130
AP Aspect Ratio Source
Selects whether the Production Aperture or the Clean Aperture is
used when converting input signals.
59
Aspect Ratio Conversion
Selects the ARC processing that the card will perform. 68
Aspect Ratio Conversion
Selects the aspect ratio conversion that the module will perform. 74
Audio Delay
Adjusts the audio delay from the card nominal. 78
Auto Recall Presets
Enables automatic preset recall when input or output changes. 141
B Gain
Varies the Gain in RGB Domain. 45
Blue Gamma Level
Adjusts the Blue Gamma levels. 46
Blue Panel
Sets the value for the B component of the background side panels. 71
C_lev
Sets the C_lev level. 95
Cb Gain
Varies the Source Cb. 45