evertz MultiFrame 7814 Series - Page 40

7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Page - 26 Revision 1.1.3
IntelliGain Mixer
(+IG Only)
Module 1 – Configuration for the first IntelliGain module.
Channels 1 - 4 - Configuration for channel swapping, audio gain, audio inversion and mono
mixing for inbound audio channels CH1, CH2, CH3, CH4 on the IntelliGain block.
Channels 5 - 8 - Configuration for channel swapping, audio gain, audio inversion and mono
mixing for inbound audio channels CH5, CH6, CH7, CH8 on the IntelliGain block.
Module 2 – Configuration for the second IntelliGain module.
Channels 1 - 4 - Configuration for channel swapping, audio gain, audio inversion and mono
mixing for inbound audio channels CH1, CH2, CH3, CH4 on the IntelliGain block.
Channels 5 - 8 - Configuration for channel swapping, audio gain, audio inversion and mono
mixing for inbound audio channels CH5, CH6, CH7, CH8 on the IntelliGain block.
IntelliGain Configuration
(+IG Only)
Configuration used to set up the IntelliGain controls including Program Configuration Source,
Content Attack and Release times, Compander Attack and Release Times and IntelliGain Audio
Sources.
IntelliGain Program
Control (+IG Only)
As IntelliGain detects valid audio programs, the VistaLINK
®
program configuration tabs will
become activated. The user interface and program configuration tabs are identical.
IG-Program 1, 2, 3, 4, 5, 6, 7, 8 – Configures the IntelliGain Program 1, 2, 3, 4, 5, 6, 7, 8
settings, including IntelliGain state, Level
er Controls, Compander controls, Peak limiter,
Maximum Gain, threshold settings and Monitoring.
IntelliGain Traps
(+IG Only)
The IntelliGain Traps are used to alert VistaLINK of all the traps for Minor, Major and Critical
loudness for each of the IntelliGain programs.
Time Code
Configuration for timecode related selection controls including D-VITC and ANC related
timecode source selections and write lines.
CC Control
Configuration for the closed captioning translation process including service level mapping and
HD write lines.
CC Fault Traps
Configuration for enabling and disabling specific Closed Captioning fault traps and viewing
Close Captioning trap status.
ANC Pass Thru
Configuration for enabling passing of specified ANC data not normally processed by the module
can be passed using these controls.
Presets
Configuration for managing card presets including storing configurations to specific user
presets, recalling specific user presets and enabling/disabling Auto Recall Presets functionality.