evertz MultiFrame 7814 Series - Page 169

7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Revision 1.1.3 Page - 155
Loss of Video Mode
Thi
s control defines the
action that will be taken
when the input video is
lost. You can choose to
freeze the output video on
the last good frame of
input video, force the
output video to black or
force the output video to
blue. The
Loss of Video
Mode drop do
wn menu
appears as follows:
9.3.1.1. Force Freeze
Frame
This control Enables or
Disables
Force Freeze
Frame. It is a manual user
control to freeze the output
of the card. When off the
module will run as
expected. When enabled
the output picture will
freeze
User Added Video Delay
Adds Additional user video delay 42
User Control
Sets the location where to store the user defined aspect ratio (10
available spots)
61
V Filter Cutoff
Sets the type of the vertical filter in the scaler. 72
V Slew Limit
Controls sharp vertical edge transitions. 71
Vertical Intensity
Sets the intensity of vertical enhancement. 49
Vertical Phase Offset
Sets the vertical phase. 42
Video Gain
Sets the video gain level. 45