SMP300 Series • Reference Information 138
Reference
Information
This section provides information about:
• Mounting the SMP300 Series
• Supported File Types, Drive Formats, Browsers, and Browser Plugins
• DataViewer
• Streaming Method Overview
• Estimating Storage Requirements for a Recording
• Front Panel Menu Diagrams
• Front Panel Menu Diagrams (Record/Stream Configuration)
Mounting the SMP300 Series
The 1U high, full rack width, 11.5 inch deep SMP300 Series Streaming Media Decoders
can be:
• Set on a table
• Mounted on a rack shelf
• Mounted under a desk or tabletop
• Mounted on a projector bracket
See the SMP300 Series product page at www.extron.com for compatible mounting kits.
Tabletop Use
The SMP300 Series includes rubber feet (not installed). For tabletop use, attach a
self‑adhesive rubber foot to each corner on the bottom of the unit.
Furniture Mounting
Furniture mount the SMP300 Series using an optional under‑desk or through‑desk
mounting kit. Follow the instructions included with the mounting kit.
Table or Wall Mounting
Extron table or wall mounting brackets extend approximately 1/4 inch (6.4 mm) above the
top surface of the SMP300 Series enclosure. This design allows an air space between the
mounting surface and the enclosure. Follow the instructions included with the mounting kit.
Rack Mounting
For rack mounting using the included rack mounts, do not install the rubber feet. Mount the
SMP300 Series on a 19inch universal or basic rack shelf.