Extron electronics SMP 300 Series User Manual

SMP300 Series • Web-Based User Interface 89
System Settings
Controls within eight of the twelve panels in the System Settings page are essential during
initial setup of the unit. The four other panels contain features used infrequently for updating
the unit, restoring a configuration, or limiting access to front panel controls.
NOTE: A user must be logged in as an administrator to see or change these settings.
Figure 68. System Settings Panels
The panels are:
1
Unit Identification — Set the system (unit) name and a description for its location. This
is also the location of the model name and description, part number, firmware version,
overall unit temperature, part number, serial number, and license information.
2
Date and Time — Set the date, time, time zone, and settings for syncing with one or
more NTP (network time protocol) servers.
3
Networking — Set the IP addresses for the unit, gateway, and DNS server, as well
as the subnet mask and port numbers for a variety of port types, or enable or disable
SNMP.
4
Recording Media Selection — Set recording parameters, such as destination,
destination priority, and secondary recording mode.
5
Recording Limits — Set recording file size and duration limits for ad hoc recordings.
6
Default Recording File Names — Choose what type of information is used to
compose names of recordings and what type of file extension (m4a, m4v, and mp4).
7
Marks and Thumbnails — Choose whether to have the SMP produce normal (small)
size thumbnail images of the recorded video or thumbnail images the same size
(resolution) as the archive encoder settings.
8
Serial — Set the baud rate and protocol for the rear panel remote control serial port.
9
Firmware and License Loader — Initiate firmware uploads and enter LinkLicense
information (see Extron LinkLicense on page3).
NOTE: All streaming configurations go back to default when firmware is updated.
¢
Backup and Restore — Back up current SMP or IP configuration settings, or restore a
previously saved configuration file.
£
Executive Mode — Enable or disable various levels of front panel lock-out to limit
access to the controls and functions of the SMP.
¤
SSL Certificate — Import user supplied SSL certificates.
Many of the system setup tasks must be performed within these pages (see the
SMP300SeriesEmbedded Web Pages Help File). However, some of the settings can also
be set using the front panel controls or Extron SIS commands.
68

Extron electronics SMP 300 Series Specifications

General

Brand	Extron electronics
Model	SMP 300 Series
Category	Computer Hardware
Language	English