·110·
Programming manual
CNC 8055
CNC 8055i
7.
ADDITIONAL PREPARATORY FUNCTIONS
·M· & ·EN· MODELS
SOFT: V02.2X
Interruption of block preparation (G04)
Example:
The following program blocks are performed in a section with G41 compensation.
...
N10 X50 Y80
N15 G04
/1 N17 M10
N20 X50 Y50
N30 X80 Y50
...
Block N15 interrupts block preparation and the execution of block N10 will finish at point A.
Once the execution of block N15 has been carried out, the CNC continues preparing blocks starting
from block N17.
As the next point corresponding to the compensated path is point "B", the CNC will move the tool
to this point, executing path "A-B".
As you can see, the resulting path is not the required one, so we recommend avoiding the use of
function G04 in sections which work with compensation.
To Next Page
Loading...
