·302·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· MODELS
SOFT: V02.2X
PROBE 3. Surface measuring canned cycle
12.5 PROBE 3. Surface measuring canned cycle
A probe placed in the spindle will be used, which must be previously calibrated by means of canned
cycles:
Tool length calibrating canned cycle.
Probe calibrating canned cycle.
This cycle allows correcting the value of the tool offset of the tool that has been used in the surface
machining process. This correction will be used only when the measurement error exceeds a
programmed value.
The programming format for this cycle is:
(PROBE 3, X, Y, Z, B, K, F, C, D, L)
[ X±5.5 ] Theoretical coordinate, along the X axis, of the point over which it is required to
measure.
[ Y±5.5 ] Theoretical coordinate, along the Y axis, of the point over which it is required to
measure.
[ Z±5.5 ] Theoretical coordinate, along the Z axis, of the point over which it is required to measure.
[ B5.5 ] Safety distance
Defines the safety distance. Must be programmed with a positive value and over 0.
The probe must be placed, with respect to the point to be measured, at a distance greater than this
value when the cycle is called.
[ K ] Probing axis
Defines the axis with which it is required to measure the surface and will be defined by means of
the following code:
K = 0 With the abscissa axis of the work plane.
K = 1 With the ordinate axis of the work plane.
K = 2 With the longitudinal axis of the work plane.
If this is not programmed, the canned cycle will take the value of K0.
[ F5.5 ] Probing feedrate
It sets the probing feedrate. It must be programmed in mm/minute or inches/minute.
[ C ] Actions after finishing the probing operation
Indicates where the probing cycle must finish.
C = 0 Will return to the same point where the call to the cycle was made.
C = 1 The cycle will finish over the measured point returning the longitudinal axis to the
cycle calling point.
If not programmed, the canned cycle will take the value of "C0".
To Next Page
Loading...
