·264·
Programming manual
CNC 8055
CNC 8055i
11.
IRREGULAR POCKET CANNED CYCLE
·M· & ·EN· MODELS
SOFT: V02.2X
3D pockets
11.2.6 Composite 3D profiles
A composite 3D profile is a 3D contour with more than one depth profile.
It is defined by means of the intersection of several contours with different depth profiles.
Each contour is defined by a profile on the plane and a depth profile, which requires the definition
of an initiation point. All the contours must meet the following conditions:
• The plane profile must contain the corresponding sides completely.
• Only a depth profile per contour must be defined.
• The plane profile and the depth profile of the contour gathering several sides must start at the
same point.
The resulting plane profile will be formed by the intersection of the plane profiles of each element
or contour.
Each wall of the resulting profile will assume the corresponding depth profile.
The CNC will interpret Pz1 and Pz3 as a straight line if the profiles are not defined; empty field.
The initial point of the intersection contour must be included on the face.
Pi Pf1
Pi Pf2
Pi Pf3
Profile resulting
from the
intersections.
Being the final
pocket to be
machined.
Pi Pf1 = Initial point of profile 1
Pi Pf2 = Initial point of profile 2
Pi Pf3 = Initial point of profile 3
Pz1
Pz2
Pz3
Pz4
Pz2 Pz1
Pz3
Pz4
To Next Page
Loading...
