Fagor 8055 M - PROBE 10. Rectangular Part Centering Canned Cycle

·326·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· MODELS
SOFT: V02.2X
PROBE 10. Rectangular part centering canned cycle
12.12 PROBE 10. Rectangular part centering canned cycle
Cycle that, with a digital probe, minimizes the preparation time of rectangular part calculating the
real coordinates of the center, of the surface and of the part inclination.
(PROBE 10, I, J, X, Y, Z, K, L, B, D, E, H, F, Q)
Initial conditions
• The probe must properly calibrated in radius and length.
• The probe position before the first probing movement must be as centered as possible in X and Y.
Considerations for the cycle
• After the probing movements, the probe withdraws from the part in G0 before moving to the safety
Z position.
• Depending on the PRBMOD variable, no error is issued in the following cases, even if machine
parameter PROBERR=YES.
 When a G75 probing move finishes before the probe has touched part.
 When a G76 probing move finishes but the probe is still touching the part.
Parameters
[ X±5.5 ] X coordinate where probing will begin
X coordinate of the probe position where the first probing move will start.
If not programmed, it will assume the current X position of the probe.
[ Y±5.5 ] Y coordinate where probing will begin
Y coordinate of the probe position where the first probing move will start.
If not programmed, it will assume the current Y position of the probe.
[ Z±5.5 ] Z coordinate where probing will begin
Z coordinate of the probe position where the first probing move will start.
If not programmed, it will assume the current Z position of the probe.
[ I5.5 ] X length of the rectangular part.
If not programmed or programmed with a 0 value, it generates the corresponding error message.
[ J5.5 ] Y length of the rectangular part.
If not programmed or programmed with a 0 value, it generates the corresponding error message.
[ K1 ] Axis and direction of the first probing movement.
The values are:
• For X+ : 0
•For X- : 1
• For Y+ : 2
•For Y- : 3
If not programmed, it assumes 0.
[ L1 ] It indicates whether the part surface is measured or not
• Value 0: It is not measured
• Value 1: It is measured
• If not programmed, a value of 0 is assumed