·148·
Programming manual
CNC 8055
CNC 8055i
9.
CANNED CYCLES
·M· & ·EN· MODELS
SOFT: V02.2X
Canned cycle definition
9.1 Canned cycle definition
A canned cycle is defined by the G function indicating the canned cycle and its corresponding
parameters.
A canned cycle cannot be defined in a block which has nonlinear movements (G02, G03, G08, G09,
G33 or G34).
Also, a canned cycle cannot be executed while function G02, G03, G33 or G34 is active. The CNC
will issue the corresponding error message.
However, once a canned cycle has been defined in a block and following blocks, functions G02, G03,
G08 or G09 can be programmed.
To Next Page
Loading...
