Fagor 8055 M - Constant Tool Center Speed (G97)

Programming manual
CNC 8055
CNC 8055i
ISO CODE PROGRAMMING
5.
·M· & ·EN· MODELS
SOFT: V02.2X
·73·
Feedrate F
5.2.4 Constant tool center speed (G97)
When G97 is programmed the CNC takes the programmed F5.5 feedrate as corresponding to the
feedrate of the center of the tool.
In this manner (working in function G97) the speed of the cutting point on the inside or outside curved
sections is reduced, keeping the speed of the center of the tool constant.
Function G97 is modal i.e. once programmed it stays active until G96 is programmed.
On power-up, after executing M02, M30 or following EMERGENCY or RESET, the CNC assumes
function G97.