·446·
Programming manual
CNC 8055
CNC 8055i
16.
ANGULAR TRANSFORMATION OF AN INCLINE AXIS
·M· & ·EN· MODELS
SOFT: V02.2X
Freezing the angular transformation
16.2 Freezing the angular transformation
Freezing the angular transformation is a special way to make movements along the angular axis,
but programming it in the Cartesian system. The angular transformation cannot be "frozen"
(suspended) while jogging.
The angular transformation is "frozen" (suspended) using function G46 whose programming format
is:
G46 S2
Programming movements after "freezing" the angular transformation.
If an angular transformation is "frozen" (suspended), only the coordinate of the angular axis must
be programmed in the motion block. If the coordinate of the orthogonal axis is programmed, the
movement is carried out according to the normal angular transformation.
Canceling the freezing of a transformation.
The "freezing" of an angular transformation is canceled after a reset or an M30. Turning the
transformation on (G46 S1) also cancels the "freezing".
To Next Page
Loading...
