Programming manual
CNC 8055
CNC 8055i
ISO CODE PROGRAMMING
5.
·M· & ·EN· MODELS
SOFT: V02.2X
·81·
Auxiliary function (M)
5.7.6 M06. Tool change code
If the general machine parameter "TOFFM06" (indicating that it is a machining center) is active, the
CNC sends instructions to the tool changer and updates the table corresponding to the tool
magazine.
It is recommended to set this function in the table of M functions, so that the subroutine
corresponding to the tool changer installed in the machine is executed.
The functions T and M06 may be programmed in the same block, regardless if they have an
associated subroutine or not. In a block where the functions T and M06 are programmed, nothing
else may be programmed.
To Next Page
Loading...
