·406·
Programming manual
CNC 8055
CNC 8055i
14.
PROGRAM CONTROL INSTRUCTIONS
·M· & ·EN· MODELS
SOFT: V02.2X
Probe related instructions
14.6 Probe related instructions
(PROBE (expression), (assignment instruction), (assignment instruction),...) )
The mnemonic PROBE calls the probe cycle indicated by means of a number or any expression
that results in a number. In addition, it allows the local parameters of this subroutine to be initialized
by means of assignment instructions.
This instruction also generates a new subroutine nesting level.
To Next Page
Loading...
