·98·
Programming manual
CNC 8055
CNC 8055i
6.
PATH CONTROL
·M· & ·EN· MODELS
SOFT: V02.2X
Automatic radius blend (G36)
6.10 Automatic radius blend (G36)
In milling operations, it is possible to round a corner via function G36 with a determined radius,
without having to calculate the center nor the start and end points of the arc.
Function G36 is not modal, so it should be programmed whenever controlled corner rounding is
required.
This function should be programmed in the block in which the movement the end you want to round
is defined.
The R5.5 value should always follow G36. It also indicates the rounding radius which the CNC
applies to get the required corner rounding. This R value must always be positive.
G90 G01 G36 R5 X35 Y60
X50 Y0
G90 G03 G36 R5 X50 Y50 I0 J30
G01 X50 Y0
To Next Page
Loading...
