·176·
Programming manual
CNC 8055
CNC 8055i
9.
CANNED CYCLES
·M· & ·EN· MODELS
SOFT: V02.2X
G84. Tapping canned cycle
Go into tool inspection
If you don't wish to finish the hole nor go to the next hole, it is possible to go into a standard tool
inspection.
In this case, a block must be selected and a standard repositioning must be done before resuming
the execution of the program.
After inspecting the tool, once repositioning is done, the following choices will be offered:
• Resume the interrupted cycle.
• Skip the interrupted cycle and resume at the next block.
To Next Page
Loading...
