·180·
Programming manual
CNC 8055
CNC 8055i
9.
CANNED CYCLES
·M· & ·EN· MODELS
SOFT: V02.2X
G86. Boring cycle with withdrawal in G00
[ D±5.5 ] Gap between the cutter and the wall of the hole on the X axis
Defines the gap between the cutter and the wall of the hole on the X axis for the withdrawal.
If not programmed, the cutter does not separate from the wall of the hole along the X axis.
Both Q and D must be programmed for the cutter to separate from the wall of the hole.
[ E±5.5 ] Gap between the cutter and the wall of the hole on the Y axis
Defines the gap between the cutter and the wall of the hole on the Y axis for the withdrawal.
If not programmed, the cutter does not separate from the wall of the hole along the Y axis.
Both Q and E must be programmed for the cutter to separate from the wall of the hole.
To Next Page
Loading...
