Programming manual
CNC 8055
CNC 8055i
IRREGULAR POCKET CANNED CYCLE
11.
·M· & ·EN· MODELS
SOFT: V02.2X
·231·
2D pockets
[ Q5.5 ] Penetrating angle
Optional. Tool penetration angle.
If not programmed or programming the value of 90, it means that the penetration is vertical. When
programming a value lower than 0 or greater than 90, it issues the error "wrong parameter value
in canned cycle".
[ F5.5 ] Machining feedrate
Optional. It sets the machining feedrate in the plane.
[ S5.5 ] Spindle speed
Optional. It sets the spindle speed.
[ T4 ] Tool number
Defines the tool used for the roughing operation. It must be programmed.
[ D4 ] Tool offset
Optional. Defines the tool offset number.
[ M ] Auxiliary (miscellaneous) functions
Optional. Up to 7 miscellaneous M functions can be programmed.
This operation allows M06 with an associated subroutine to be defined, and the tool change is
performed before beginning the roughing operation.
To Next Page
Loading...
