Programming manual
CNC 8055
CNC 8055i
IRREGULAR POCKET CANNED CYCLE
11.
·M· & ·EN· MODELS
SOFT: V02.2X
·247·
3D pockets
Basic operation
1. Roughing operation. Only if it has been programmed.
It consists of several surface milling passes, until the total depth programmed has been reached.
On each surface milling pass, the steps below will be followed depending on the type of
machining that has been programmed:
Case A:
When the machining paths are linear and maintain a certain angle with the abscissa axis.
It first contours the external profile of the part. If the finishing operation has been selected on
the cycle call, this contouring is performed leaving the finishing stock programmed for the
finishing pass.
Next the milling operation, with the programmed feed and steps. If, while milling, an island is run
into for the first time, it will be contoured.
After the contouring and the remaining times, the tool will pass over the island, withdrawing along
the longitudinal axis, to the reference plane, and will continue machining once the island has
been cleared.
To Next Page
Loading...
