CNC 8055
CNC 8055i
·M· & ·EN· MODELS
SOFT: V02.2X
12
·285·
PROBING
The CNC has two probe inputs, one for TTL-type 5Vdc signals and another for 24 Vdc signals.
The connection of the different types of probes to these inputs are explained in the appendix to the
Installation manual.
This control allows the following operations to be performed, by using probes:
• Programming probing blocks with functions G75 and G76.
• Execution of the various tool calibration, part-measurement and part centering cycles by means
of high-level language programming.
To Next Page
Loading...
