Fagor 8055 M - Page 292

·292·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· MODELS
SOFT: V02.2X
PROBE 1. Tool length calibrating canned cycle
Actions after finishing the cycle
Once the calibration cycle has ended
It updates global arithmetic parameter P299 and assigns the measured length to the tool offset
selected in the tool offset table.
P299 "Measured length" - "Previous length (L+K)".
L Measured length.
K0.
Once the wear measuring cycle has ended
• When using tool live monitoring.
In this case, it compares the measured value with the theoretical length assigned in the table.
If the permitted maximum value is exceeds, it issues the message indicating that the tool has
been rejected and acts as follows.
• If tool life monitoring is not available or the measuring difference does not exceed the maximum
allowed.
In this case, it updates global arithmetic parameter P299 and the length wear value of the tool
offset selected in the tool offset table.
P299 "Measured length" - "Theoretical length (L)".
L Theoretical length. It maintains the previous value.
K "Measured length" - "Theoretical length (L)". New wear value.
If the dimension of each cutting edge was requested (“N” parameter) the measured values are
assigned to global arithmetic parameters P271 and on.
C0 It interrupts the execution so the user can select another tool.
C1 The cycle replaces the tool with another one from the same family. It sets the "rejected
tool " indicator (status = R). It activates the general logic output PRTREJEC (M5564).