Fagor 8055 M - Page 319

Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· MODELS
SOFT: V02.2X
·319·
PROBE 7. Corner and angle measuring canned cycle.
8. Withdrawal movement.
Movement of the probe in rapid (G00) from the third probing point to the point where the cycle
was called.
The withdrawal movement is made in three stages:
·1· Movement along the probing axis to the second approach point.
·2· Movement along the longitudinal axis to the coordinate of the point (along this axis) from
where the cycle was called.
·3· Movement in the main work plane to the point where the cycle is called.
Arithmetic parameters modified by the cycle
Once the cycle has been completed, the CNC will return the real values obtained after
measurement, in the following global arithmetic parameters.
Considerations for the cycle
This cycle may be used to measure angles between ±45º.
• If the angle to be measured is > 45º, the CNC will display the corresponding error.
• If the angle to be measured is < -45º, the probe will collide with the part.
P295 Inclination angle which the part has in relation to the abscissa axis.
P296 Real coordinate of the corner along the abscissa axis.
P297 Real coordinate of the corner along the ordinate axis.
P298 Error detected along the abscissa axis. Difference between the real coordinate of the
corner and the theoretical programmed coordinate.
P299 Error detected along the ordinate axis. Difference between the real coordinate of the
corner and the theoretical programmed coordinate.