·330·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· MODELS
SOFT: V02.2X
PROBE 11. Circular part centering canned cycle.
[ D±5.5 ] Probe's up distance along Z.
Distance for the probe to go up in Z for its movements over the part. If not programmed or
programmed with a 0 value, it generates the corresponding error message.
[ E±5.5 ] Probe withdrawal distance
Distance the probe retracts after finding the part, to make the measurement. If not programmed or
programmed with a 0 value, it generates the corresponding error message.
[ H5 ] Probing feedrate for searching the part.
If not programmed or programmed with a 0 value, it generates the corresponding error message.
[ F5 ] Probing feedrate for measuring.
If not programmed or programmed with a 0 value, it generates the corresponding error message.
[ Q5 ] Probe feedrate when going to the approach points.
If not programmed, it assumes in G0.
To Next Page
Loading...
