Fagor 8055 M - Page 335

Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· MODELS
SOFT: V02.2X
·335·
PROBE 12. Tabletop probe calibration
30.Probing movement (at the feedrate given in H) until touching that side.
31.Rapid withdrawal (distance given in E) for the measuring probing movement.
32.Probing movement (at the feedrate given in F) until touching the same side again.
33.Rapid withdrawal on the Y axis up to the approach position.
34.Rapid withdrawal in Z up to the Z approach coordinate.
35.Rapid movement up to the starting XY point.
36.Rapid withdrawal in Z up to the Z starting coordinate.
37.If it is a double calibration, orient the spindle at 180º and repeat steps 2 through 36.
38.Setting the relevant parameters with the real values of the sides of the calibrated probe.
Arithmetic parameters modified by the cycle
Once the cycle has been completed, the CNC will return the real values obtained after
measurement, in the following global arithmetic parameters.
P295 Real coordinate of the least positive side of the probe, along the abscissa axis.
P296 Real coordinate of the most positive side of the probe, along the abscissa axis.
P297 Real coordinate of the least positive side of the probe, along the ordinate axis.
P298 Real coordinate of the most positive side of the probe, along the ordinate axis.
P299 Real coordinate of the measured probe side along the longitudinal axis.