Programming manual
CNC 8055
CNC 8055i
HIGH-LEVEL LANGUAGE PROGRAMMING
13.
·M· & ·EN· MODELS
SOFT: V02.2X
·363·
Variables
SSLIMI
It returns the value set in rpm at the CNC for the turning speed limit of the second spindle.
This limit may be indicated by program, by PLC or by DNC; the CNC selects one of them, the one
indicated by DNC has the highest priority and the one indicated by program has the lowest priority.
SDNCSL
It returns the speed limit of the second spindle in rpm currently selected via DNC. If it has a value
of 0 it means that it is not selected.
SPLCSL
It returns the speed limit of the second spindle in rpm currently selected by PLC. If it has a value
of 0 it means that it is not selected.
SPRGSL
It returns the speed limit of the second spindle in rpm currently selected by program.
SPOSS
It returns the real position of the second spindle. Its value may be within ±99999.9999°.
SRPOSS
It returns the real position of the second spindle. Its value is given in 0.0001 degree units (between
-360º and 360º).
STPOSS
It returns the theoretical position of the second spindle (real position + lag). Its value may be within
±99999.9999º.
SRTPOS
Returns the second spindle's theoretical position value (real coordinate+ following error) in a 360º
module. Its value may be between 0 and 360º.
SDRPOS
Position indicated by the Sercos drive of the second spindle.
SPRGSP
Position programmed in M19 via program for the second spindle. This variable may be read from
the CNC, from the PLC and from DNC.
SFLWES
It returns the second spindle's following error in degrees (within ±99999.9999).
When accessing one of these variables SPOSS, SRPOSS, STPOSS, SRTPOSS or SFLWES, block
preparation is interrupted and the CNC waits for that command to be executed before resuming block
preparation.
To Next Page
Loading...
