Fagor 8055 M - Page 374

·374·
Programming manual
CNC 8055
CNC 8055i
13.
HIGH-LEVEL LANGUAGE PROGRAMMING
·M· & ·EN· MODELS
SOFT: V02.2X
Variables
HARTST
It returns the result of the hardware test. The data comes at the least significant bits with a "1" if it
failed and with a "0" if OK or if the relevant board is missing.
MEMTST
It returns the result of the memory test. Each data uses 4 bits that will be at "1" if the test is OK and
will have a value other than "1" if there is an error.
Bit 30 stays at "1" during the test.
NODE
It returns the number of the node used to configure the CNC in the Sercos ring.
VCHECK
It returns the checksum of the code for the software version installed. It is the value appearing on
the code test.
IONODE
It returns in 16 bits the position of the "ADDRESS" switch of the CAN of the I/O. If it is not connected,
it returns the value 0xFFFF.
IOSLOC
They may be used to read the number of local digital I/O available.
Bits
14 24V test of IO4 module
13 Inside temperature
12 I/O 3 (Board voltage)
11 I/O 2 (Board voltage)
10 I/O 1 (Board voltage)
8 Axes (Board voltage)
7 +3.3 V (Power supply)
6 11 (Power supply)
5 GNDA (Power supply)
4 - 15 V (Power supply)
3 + 15 V (Power supply)
2 Battery (Power supply)
1 - 5 V (Power supply)
0 (LSB) + 5 V (Power supply)
Bits Test
30 Test status
... ...
... ...
19 - 16 Caché
Bits Test
15 - 12 Sdram
11- 8 HD
7 -4 Flash
3 - 0 (LSB) Ram
Bit Meaning
0 - 15 Number of inputs.
16 - 31 Number of outputs.