Programming manual
CNC 8055
CNC 8055i
ISO CODE PROGRAMMING
5.
·M· & ·EN· MODELS
SOFT: V02.2X
·71·
Feedrate F
5.2.2 Feedrate in mm/rev.or inches/rev (G95)
From the moment when the code G95 is programmed, the control assumes that the feedrates
programmed through F5.5 are in mm/rev or inches/mm.
This function does not affect the rapid moves (G00) which will be made in mm/min or inch/min. By
the same token, it will not be applied to moves made in the JOG mode, during tool inspection, etc.
Function G95 is modal i.e. once programmed it stays active until G94 is programmed.
On power-up, after executing M02, M30 or following EMERGENCY or RESET, the CNC assumes
function G94 or G95 according to how the general machine parameter "IFEED" is set.
To Next Page
Loading...
