Fagor 8055i FL EN - Page 5

Operating manual
CNC 8055
CNC 8055i
SOFT: V02.2X
·5·
CHAPTER 6 SAVING PROGRAMS
6.1 List of saved programs................................................................................................. 186
6.2 See the contents of a program..................................................................................... 187
6.2.1 Seeing one of the operations in detail...................................................................... 187
6.3 Edit a new part-program .............................................................................................. 188
6.4 Saving an ISO block or a cycle .................................................................................... 189
6.5 Delete a new part program .......................................................................................... 190
6.6 Copying a part-program into another one .................................................................... 191
6.7 Modify a part-program.................................................................................................. 192
6.7.1 Delete an operation.................................................................................................. 192
6.7.2 Add or insert a new operation .................................................................................. 192
6.7.3 Move an operation to another position..................................................................... 193
6.7.4 Modify an existing operation .................................................................................... 194
6.8 Managing programs using the explorer ....................................................................... 195
CHAPTER 7 EXECUTION AND SIMULATION
7.1 Simulating or executing an operation or cycle ............................................................. 198
7.2 Simulating or executing a part-program....................................................................... 199
7.2.1 Simulating or executing a portion of a part-program ................................................ 199
7.3 Simulating or executing an operation that has been saved ......................................... 200
7.4 Execution mode ........................................................................................................... 201
7.4.1 Tool inspection ......................................................................................................... 202
7.5 Graphic representation ................................................................................................ 203