Festo CPX-CMAX-C1-1 User Manual

5. Parameter
5−40
Festo P.BE−CPX−CMAX−CONTROL−EN en 0908NH
Pressure values
PNU PNU: 302 Index: 1 ... 3 Max index: 3 Class: Array Data type: int32
Values Unit: Pressure (index = 4)
Linear drive Semi−rotary drive
Dimension Default Minimum Maximum Dimension Default Minimum Maximum
SI 0,1 bar − −120 120 0,1 bar − −120 120
Imperial 1 psi − −174 174 1 psi − −174 174
Index Value
1 Pressure valve chamber 1
2 Pressure valve chamber 2
3 Calculated supply pressure
ý The parameter value cannot be changed.
o Writing permissible only in commissioning/parametrising mode with disabled controller.
o This parameter can be written by FCT without higher−order controller.
o After writing, controller recalculation is carried out.
Count of positioning commands
PNU PNU: 305 Index: 1 Max index: 4 Class: Struct Data type: int32
Values Without unit
Default: 0 Minimum: 0 Maximum: 2.147.483.647
Total of start commands of the position controller that were executed.
Jogging, homing or identifications are not counted.
ý The parameter value cannot be changed.
o Writing permissible only in commissioning/parametrising mode with disabled controller.
o This parameter can be written by FCT without higher−order controller.
o After writing, controller recalculation is carried out.
Count of force commands
PNU PNU: 305 Index: 2 Max index: 4 Class: Struct Data type: int32
Values Without unit
Default: 0 Minimum: 0 Maximum: 2.147.483.647
Total of start commands of the force control that were executed.
ý The parameter value cannot be changed.
o Writing permissible only in commissioning/parametrising mode with disabled controller.
o This parameter can be written by FCT without higher−order controller.
o After writing, controller recalculation is carried out.

Festo CPX-CMAX-C1-1 Specifications

General

Brand	Festo
Model	CPX-CMAX-C1-1
Category	Controller
Language	English