18 SuperUser mode
FLUXUS F60* 18.3 Definition of the flow parameters
177
UMFLUXUS_F60xV5-0EN, 2017-10-16
18.3.2 Correction of the flow velocity
After the profile bounds have been defined, it is possible to define a correction of the flow
velocity:
v
cor
= m · v + n
where
All quantities derived from the flow velocity will be calculated with the corrected flow ve-
locity. The correction data will be transmitted to the PC or printer during the online or
offline transmission.
• Select on to define the correction data, off to work without correction of the flow veloc-
ity and return to the menu item SYSTEM settings.
•If on is selected, enter the slope. The input 0.0 deactivates the correction.
• Press ENTER.
• Enter the offset. Enter zero to work without offset.
• Press ENTER.
v – measured flow velocity
m – slope, range: -2.0...+2.0
n – offset, range: -12.7…+12.7 cm/s
v
cor
– corrected flow velocity
It will not be displayed that the correction of the flow velocity is active during the
measurement.
Special Funct.\...\Calibration\...\Calibration
Special Funct.\...\Calibration\...\Calibration\Slope
Special Funct.\...\Calibration\...\Calibration\Offset
To Next Page
Loading...
Need help?
General
