FlexRadio Systems FLEX-6000 Signature Series User Manual

FLEX-6000 Signature Series - SmartSDR for Windows Software User’s Guide
Page 175
Copyright 2018 FlexRadio Systems. All Rights Reserved.
• The Mode Menu button displays the mode that is currently selected. Inside the menu there
is a mode drop-down menu and three quick-select modes. To change the quick-select
modes to a different mode, use a right click to expose a drop-down menu of available
modes. Beneath the mode select buttons are the mode specific Filter Presets.
• The X/RIT Menu has controls for RIT and XIT. You can enable RIT or XIT by clicking the
corresponding button. When enabled the button will turn blue. Modify the offset by
clicking the right or left arrows or by typing in the text box. Click the button to clear
the offset. You can also control RIT and XIT on the FlexControl using the default settings by
clicking the AUX1 button to enable RIT and AUX3 for XIT. Double click the tuning knob to
zero out the RIT/XIT. Double click the corresponding AUX button to disable RIT/XIT, and
zero it out.
• When RIT/XIT is set to something other than 0 the slice’s transmit filter bandwidth will be
displayed on the Panadapter as a red bar. The bar is located behind the receive filter and
will often overlap as shown below. Also, when RIT is adjusted a red dotted line will appear
to show the original location of your receiver to where your slice will return upon zeroing
out RIT.

FlexRadio Systems FLEX-6000 Signature Series Specifications

General

Brand	FlexRadio Systems
Model	FLEX-6000 Signature Series
Category	Transceiver
Language	English