FLEX-6000 Signature Series - SmartSDR for Windows Software User’s Guide
Page 74
Copyright 2018 FlexRadio Systems. All Rights Reserved.
Slice Receiver A should be tuned to the DX station’s transmitting frequency. Slice Receiver B should
be selected as the active slice, so you can tune your transmitter to the DX station’s listening
frequency.
If you prefer, you can use the slice audio controls to pan the slice audio so one receiver is in your left
ear and the other is in your right ear. A single click on the L or R will move the control one step to
the left or right. If the control is in the center, clicking on the R will move the control all the way to
the right. Clicking on the L will move the control back to the center. Clicking on the L again will move
the control all the way to the left.
19.2 CW TRANSMITTING
To transmit in CW mode using the keyer built-into the Flex-6000 radio, you will need either a straight
key or an iambic paddle. Refer to the FLEX-6000 Hardware Reference Manual for wiring instructions.
To use a straight key, uncheck the IAMBIC control in the CW transmit panel. The BREAKIN control
allows automatic PTT when the key is pressed. The Delay slider sets the PTT hold time for break-in
in milliseconds. It can be set anywhere from zero (full QSK), to 2000 milliseconds (2 seconds). See
section 37.7.2 for details about these controls.
19.3 USING THE BUILT-IN KEYER
The radio has a built-in iambic keyer that can be used either as iambic “A” or iambic “B”. Controls
for the keyer are found on the Phone/CW tab of the Radio Setup panel. See section 35.7 for details
about these controls.
To Next Page
Loading...
Need help?
General
