FLEX-6000 Signature Series - SmartSDR for Windows Software User’s Guide
Page 182
Copyright 2018 FlexRadio Systems. All Rights Reserved.
• SWR: The standing wave ratio, calculated by the amplifier from the forward and reverse
power values. Note that the smallest value reported by this meter is 1.2:1.
• Temp: The output power transistor heatsink temperature, in degrees Celsius.
37.8 SMARTSDR CWX PANEL
CWX is a keyboard entry method for CW operation. The user types a message into the blue text
bubble to be sent by the radio. There are two methods of sending messages “Live” and “Standard”
• Live mode of operation is enabled when the Live button is highlighted in Red. While
in live mode, text will be transmitted as the user types into the text bubble.
• In Standard mode, the text will not be transmitted until the user hits the “Send” button or
presses the “Enter” key.
As text is transmitted the font color will change from black to white indicating that the transmission
has occurred. The user can stop transmission at any point by pressing the “Escape” key on the
keyboard or tapping your paddle or key.
After a message has been sent the user can right click on the sent message to bring up a context
menu that allows the user to resend the message or clear the history of the conversation.
CWX also supports several prosigns that can be entered in the CWX text bubble.
To insert Prosign BT use =
To insert Prosign AR use +
To insert Prosign KN use (
To Next Page
Loading...
Need help?
General
