63
5-4. Preview Function
The preview function allows you to set an output to be used for the preview.
(ex.) When pressing a source button on the remote control panel for a simultaneous
crosspoint switch, the selected source will be output to the preview output. Then you can
check images of the source channels to be assigned to a Take.
When pressing a destination button, the source channel assigned for the destination channel
will be output to the preview output.
Assigning Operation Preview to a Button on the Front Panel
► See Sec. 4-4-4. "Button Assign Menu.".
Outputing the Operation Preview
Press the O-PREVIEW button on the remote control unit to output the preview signal from the
set destination channel.
5-5. Level Control
Generally, routing switchers control crosspoints according to the signal types such as video,
audio, time codes, and VCR control. To control switchers, level numbers are used to identify
which type of signal to control.
In the above example, if you select Level No. 1 for the current level, you can switch
crosspoints that are set to Level 1. If you select Level No. 2, you can switch crosspoints on
Level 2. If you select multiple levels, you can switch crosspoints on all of the selected levels
at the same time.
Assigning levels
Signals can be assigned to logical inputs and outputs using Web-based Control. When
assigning the signals, select a level for respective signals to be assigned to the respective
levels.
Video signal
Source channel
Level No. 3 Audio signal 2
Level No. 2 Audio signal 1
Video signal
Destination channel
Audio signal 1
Source channel
Audio signal 1
Destination channel
Audio signal 2
Source channel
Audio signal 2
Destination channel
To Next Page
Loading...
