FOR-A MFR-3000 - User Manual

98 pages

Save Page as PDF

To Next Page

MFR-3000

Multi Format Routing Switcher

MFR-30FP

MFR-GPI

MFR-TALM

Edition - Rev. 2

OPERATION

MANUAL

Main Page

Questions and Answers

L
lindafowlerSep 8, 2025
How to fix no image output on FOR-A MFR-3000 Switch?
- A
  april52Sep 8, 2025
  If you're experiencing a 'no image output' issue with your FOR-A Switch, first ensure that video signals are correctly input to the video input connectors. Also, verify that all cables are properly connected for the signal inputs. Finally, make sure that the crosspoint is set correctly. These steps should resolve the issue.
M
millerrodneySep 12, 2025
What to do if the secondary CPU is active on FOR-A MFR-3000?
- S
  Stephanie PetersonSep 12, 2025
  If the secondary CPU is active on your FOR-A Switch, ensure that both MFR-LAN 1 and MFR-LAN 2 are properly connected to the network. Check both the cable and Ethernet hub connections. If the network connections are correctly made, try turning the unit power off and then on again. If the secondary CPU is still active after restarting, consult your FOR-A reseller.
W
walkerjaneSep 12, 2025
What to do if there is no image output from my FOR-A Switch?
- K
  Katherine ClarkSep 13, 2025
  If you're not getting any image output from your FOR-A Switch, first ensure that video signals are being input to the video input connectors. Check that the cables are properly connected for the signal inputs. Also, verify that the crosspoint is set correctly.
C
Cody YoungSep 14, 2025
Why I am unable to control FOR-A Switch using the remote control panel?
- S
  Scott ColeSep 15, 2025
  If you cannot control your FOR-A Switch using the remote control panel, ensure that the LAN cable is properly connected. Also, check the RU Info page in the Web-based Control to see if it indicates 'NG'. If it does, check the item indicated as 'NG'; however, if the Voltage is indicated as 'NG', contact your FOR-A agent.
D
Denise GutierrezSep 16, 2025
What to do if I cannot control FOR-A MFR-3000 using the remote control panel?
- H
  Holly CarpenterSep 16, 2025
  If you are unable to control your FOR-A Switch using the remote control panel, ensure that the LAN cable is properly connected. Additionally, check the RU Info page in the Web-based Control to see if it indicates 'NG' for any items. If 'Voltage' is indicated as 'NG', contact your FOR-A agent.

FOR-A MFR-3000 Specifications

General

Audio Inputs	Embedded audio support
Audio Outputs	Embedded audio support
Size	5RU
Video Inputs	Up to 64 inputs
Control Interface	Ethernet, RS-422
Supported Formats	HD, SD
Redundancy	Power supply