Fujitsu ETERNUS CS800 - Page 340

10.9 System
Tasks
Use the Access Control Settings page to perform the following tasks:
l Change the administrator password (see "Changing GUI Administrator Password" on
page 340).
l Enable or disable GUI access for the monitor account (see "Enabling GUI Monitor
Account" on page 340).
l Enable or disable CLI access for the administrator or viewer account (see "Enabling CLI
Accounts" on page 341).
l Enable or disable GUI access for the service account (see "Enabling GUI Service
Account" on page 345).
l Enable or disable SSH access for the service account (see "Enabling SSH Service
Account" on page 346)
Changing GUI Administrator Password
Use the GUI password when logging onto the remote management console as an
administrator (see "Accessing Remote Management" on page 133).
1. Under GUI Administrator, enter the following information:
Old Password Enter the old password.
New Password Enter the new password.
Confirm New Password Enter the new password again to confirm it.
Additional Information
l Passwords can be up to 32 characters. Alphanumeric characters and special
characters are allowed.
l Loss of this password will require Fujitsu Technology Solutions service support.
2. Click Apply.
Enabling GUI Monitor Account
Use the GUI password when logging onto the remote management console as a monitor (see
"Accessing Remote Management" on page 133).
1. Under GUI Monitor do one of the following steps:
l Select the Enable GUI Monitor Login check box to enable the GUI monitor
account.
l Clear the Enable GUI Monitor Login check box to disable the GUI monitor
account.
2. Enter the following information:
340 ETERNUS CS800