3.6 Using the Network Settings Menus
Network Scanner fi-6000NS Operator's Guide 107
Administrator Operations
3
5. Set the width to be removed from the edges of the scanned data.
The default is "2" mm.
The width must be set between 0 mm and 5 mm. If margin removal is not required, enter "0"
mm.
6. Press the [OK] button.
⇒ The width to be removed from the edges of the scanned data is set.
When this setting is enabled, and 600dpi resolution is selected, scanning
may take a long time than usual.
Scanned Data
Print Sheet
Scanned Data
Print Sheet
No Margin Removal Margin Removal
Edge of Scanned Data
Margin Removal
Frame of Scanned Data
To Next Page
Loading...
