5.5 Replacing Parts
Network Scanner fi-6000NS Operator's Guide 281
Scanner Care
5
5.5.1 Replacing the Pad Assembly
1. Remove any documents from the ADF paper chute.
2. Push the ADF release button, then hold both sides of the top cover and lift it open.
3. Remove the pad assembly from the scanner.
Squeeze the prongs on either side of the pad assembly together and pull it upwards and to
the front, taking care not to snag the pick springs.
4. Insert the new pad assembly.
Holding the new pad assembly by its sides, insert into the pad assembly socket, taking care
not to snag the pick springs.
Be careful that the top cover does not shut on your fingers.
Make sure that the pad assembly is firmly and fully inserted. If it is
not correctly attached, document jams and other feeding errors may
occur.
Squeeze prongs together and pull up
To Next Page
Loading...
