Fujitsu FI-6000NS - Setting the Time to Standby Mode

3.5 Using the System Settings Menus
Network Scanner fi-6000NS Operator's Guide 57
Administrator Operations
3
3.5.5 Setting the Time to Standby Mode
The scanner can be set to automatically log out and then enter a standby state after specified peri-
ods of non-use.
For any screen after regular user login, if no operations have been performed for the specified
"Logout after" period of time, the scanner automatically logs the user out.
If no operations are performed for the specified "Standby after" period of time, the scanner enters
standby mode. The touch panel is switched off when the scanner enters standby mode.
When the startup button is pressed, the "Login" screen will appear.
1. Select the [System Settings] tab on the top menu.
2. Press the [Down] button on the left side menu.
⇒ Scroll the left side menu down until the [Standby Mode] tab appears.
HINT
The scanner will not logout while the following operations are ongoing:
• Scanning documents
• e-Mailing a scan
• Faxing a scan
• Printing a scan
• Saving a scan