Fujitsu FI-6000NS - User Log; C.2.3 User Log

Network Scanner fi-6000NS Operator's Guide 393
C
C.2.3 User Log
Code Message Action
00000000 --------------------------- No action required.
12010001 Scanned data size exceeded
maximum size allowed for e-
mail attachments.
Try the following:
• Reduce the number of pages to be
scanned and send the e-mail in separate
parts.
• Select a higher compression level and
try again.
"4.8.8 Compression" (page 247)
If the problem persists, contact a system
administrator to check the "Maximum
Attachment Size" setting.
"3.6.6 Setting the e-Mail Server (SMTP
Server)" (page 84)
12010002 Could not connect to server
when sending e-mail.
Try the following:
• Check that the LAN cable of the scanner
and SMTP server is connected properly.
• Contact a system administrator to check
that then scanner IP address and SMTP
server settings are correct.
"6.3 Network Connection
Troubleshooting" (page 296)
• Contact a system administrator to check
that the SMTP server is working prop-
erly.
12010003 "From" address was rejected by
the server when sending e-mail.
Contact a system administrator to check
that the specified e-mail source address is
authorized for use on the server.
12010004 "To" address was rejected by
the server when sending e-mail.
Contact a system administrator to check
that the specified e-mail destination
address is authorized for use on the server.
12010005 e-Mail size exceeded maxi-
mum e-mail size allowed by the
SMTP server.
Contact a system administrator to check
the maximum e-mail size allowed by the
SMTP server.