4.4 Sending the Scanned Data by e-Mail
Network Scanner fi-6000NS Operator's Guide 187
Regular User Operations
4
3. Enter a file name for the scan data into the "File Name:" field.
The file name may be up to 128 characters long.
By default, "Scanner Name" + "Scan Date/Time" is entered.
4. Check that address shown in the "From:" field is correct.
Note that no address is shown if a LDAP server is not being used, or if no e-mail address for
the authenticated user has be registered in the LDAP server. In this case, directly enter the
sender's e-mail address using the keyboard.
e-Mail addresses may be up to 255 characters long. Alphanumeric characters and the follow-
ing symbols can be used.
- . _ @
However, _ can only be used before @.
(Refer to Step 2 for complete details.)
5. Enter an e-mail title into the "Subject:" field.
The subject may be up to 128 characters long.
The following file names cannot be used:
• CON
• PRN
• AUX
• CLOCK$
• NUL
• COM0 to COM9
• LPT0 to LPT9
To Next Page
Loading...
