Network Scanner fi-6000NS Operator's Guide 325
A
Take the following precautions when scanning plastic cards (for
example ID cards).
• In Scan Settings, set the Multifeed Setup to [None]. For more details
about Multifeed Setup, refer to "4.8.13 Multifeed Detection (Layer
and Length)" (page 256).
• Place one card at a time into the ADF paper chute.
• Cards must be fed through the ADF in portrait mode, as in the fol-
lowing figure.
• Cards should be placed face down in the ADF paper chute.
• Embossed cards should be placed with the raised lettering side
down.
• Cards should be of the following specifications:
ISO7810-compliant, Type ID-1 cards
Width
× Length: 2.1in X 3.4in / 54mm X 86mm
Thickness: 0.03 ± 0.003in / 0.76 ± 0.08mm
Material: PVC (polyvinyl chloride) or PVCA (polyvinyl chloride ace-
tate)
• Cards that are excessively rigid may not be fed smoothly by the
ADF.
• Cards that have become dirty from handling should be wiped clean
before scanning.
Back
side
PORTRAIT
LANDSCAPE
To Next Page
Loading...
