Network Scanner fi-6000NS Operator's Guide 365
C
Scanning Top cover may be open. Close the top
cover, reload the documents and try
again.
Close the top cover, reload the
documents and try again.
Feed Error: Document(s) may not
match the set paper size, ADF may
have grabbed more than one sheet, or
documents may not be suitable for
scanning. Remove the documents
from the ADF, check them and try
again. If problem persists, consult the
manual.
Press the ADF release button to
open the top cover, and remove the
documents from the ADF. If more
than one sheet has been fed, reset
the document and try again.
Check that the actual document(s)
size matches the paper size speci-
fied in the "Paper Size" screen. If
not, specify the paper size again.
For details, refer to "4.8.3 Paper
Size" (page 234).
Insufficient memory. Try turning the
power off and back on again. If prob-
lem persists, the administrator should
contact the FUJITSU scanner dealer or
an authorized FUJITSU scanner ser-
vice provider for help
Try the following:
• Reduce the size of the scan data
or set a lower resolution level,
and try again.
• System might be unstable.
If the scanner does not restart
automatically, try turning the
power off for ten seconds, and
back on again. If the error status
persists, contact your FUJITSU
scanner dealer or an authorized
FUJITSU scanner service pro-
vider.
An error has occurred. Some pages
were skipped. Try again after turning
the power off and back on again. If
problem persists, the administrator
should contact the FUJITSU scanner
dealer or an authorized FUJITSU
scanner service provider for help.
Number of Skipped Pages:
If the scanner does not restart auto-
matically, try turning the power off
for ten seconds, and back on again.
If the problem persists, contact
your FUJITSU scanner dealer or
an authorized FUJITSU scanner
service provider.
Screen Message Action
To Next Page
Loading...
