66
5. In Step 4, if [Middle] or [Top & Bottom] is selected, enter both "#1" (upper limit) and
"#2" (lower limit).
#1: Even numbers from 0 to 508mm can be entered. Odd numbers will be made even by
adding one.
#2: Even numbers from 0 to 510mm can be entered. Odd numbers will be made even by
adding one.
6. Press the [OK] button.
⇒ The document area to be monitored for multifeeds is set.
• Specify a lower value for "#1" than for "#2".
• "#2" can have a maximum value of 510mm. If the paper size setting
is long page mode but the length of the document is longer than
510mm, multifeed cannot be detected by length.
• When [Middle] is selected, if the document is shorter than "#1", multi-
feed will not be detected. When [Top & Bottom] is selected, if the
document is shorter than "#2", multifeed will not be detected for the
bottom part.
• If the values specified for "#1" and "#2" exceed the actual paper size,
multifeeds will not be detected.
To Next Page
Loading...
