3.6 Using the Network Settings Menus
Network Scanner fi-6000NS Operator's Guide 71
Administrator Operations
3
3. Select whether or not a DHCP is required.
Set the scanner's IP address. This may be done automatically, by pressing the DHCP [On]
button. By default, this is set as [On].
The IP address may also be set manually, by pressing the DHCP [Off] button and entering
the following numerical addresses:
• IP Address
• Subnet Mask
• Default Gateway
4. Press the [OK] button.
⇒ The information entered is set.
To Next Page
Loading...
