Use e Maintenance ENGLISH
Maintenance in safety
During work and maintenance operations, use
suitable personal protection gear:
Overalls Gloves Shoes Goggles Hardhat
1. Do not proceed with maintenance and cleaning if the
power take-off has not been disconnected first, the
engine power off, the hand brake pulled and the trac-
tor blocked with a wooden block or stone of the right
size under the wheels.
2. Periodically check that the bolts and nuts are tight,
and if necessary tighten them again. For this it would
be advisable to use a torque wrench, respecting the
values of 53 Nm for M10 bolts, resistance class 8.8,
and 150 Nm for M14 bolts resistance class 8.8 (fig.
2.4).
3. During assembling, main-tenance, cleaning, fitting,
etc., with the seeding machine raised, place ade-
quate supports under the equipment as a precaution.
4. The spare parts must correspond to the manufac-
turer’s specifications. Use only original spares.
Figure 2.4: Screw tightening torque
Cod. F07011577 EN - 15
To Next Page
Loading...
