AT600 User’s Manual 97
Chapter 5. Communication
Command 153 (0x99): Write Density Value
This command will write density value in meter.
Table 36: Request Data Bytes for Write Density Value
Byte Format Description
0 Unsigned-8 Density type:
1: Actual Density;
2: Reference Density;
1 Unsigned-8 Density Unit Code
2 - 5 Float Density value
Table 37: Response Data Bytes for Write Density Value
Byte Format Description
0 Unsigned-8 Density type:
1: Actual Density;
2: Reference Density;
1 Unsigned-8 Density Unit Code
2 - 5 Float Density value
Table 38: Command-Specific Response Codes for Write Density Value
Code Class Description
0 Success No Command-Specific Errors
1Undefined
2 Error Invalid Selection
3 - 4 Undefined
5 Error Too Few Data Bytes Received
6 Error Device-Specific Command Error
7Error In Write Protect Mode
8 - 15 Undefined
16 Error Access Restricted
17 - 127 Undefined
To Next Page
Loading...
